How to Add Hydraulic Fluid to Excavator
Excavators are one of the most common pieces of equipment used in construction and mining. They are large machines that are used to dig holes or trenches, or to move large pieces of debris.
Hydraulic fluid is what makes an excavator work. It is a special oil that is used to lubricate and cool the moving parts of the machine. When the hydraulic fluid level gets low, it can cause the excavator to overheat and break down.
Adding hydraulic fluid to an excavator is a simple task that can be done by anyone. In this article, we will show you how to add hydraulic fluid to an excavator.
How to Add Hydraulic Fluid to Excavator
Adding hydraulic fluid to an excavator is a crucial maintenance task that helps keep the machinery running smoothly. We will go over the steps you need to follow to properly add hydraulic fluid to your excavator.
To add hydraulic fluid to an excavator,
- Locate the hydraulic fluid reservoir: The hydraulic fluid reservoir is usually located near the back of the excavator, close to the hydraulic pump. It is usually a large, rectangular tank with a cap on top.
- Remove the fill cap and clean it with a rag to remove any dirt or debris that may be blocking the opening.
- Prepare the hydraulic fluid: Before you add the hydraulic fluid, you need to make sure that you are using the correct type and grade of fluid for your excavator. Consult your owner’s manual or the manufacturer’s specifications to determine the correct type of fluid to use.
- Check the fluid level: Once you have located the hydraulic fluid reservoir, check the fluid level using the dipstick or sight gauge on the side of the tank. If the fluid level is low, proceed to the next step. If the fluid level is already at the full mark, do not add more fluid.
- Add the hydraulic fluid: Open the cap on top of the hydraulic fluid reservoir and pour the fluid in slowly, making sure not to overfill the tank. Use a funnel if necessary to avoid spilling the fluid.
- Check for leaks: After adding the hydraulic fluid, check the excavator for any leaks. If you find any leaks, repair them immediately to prevent further damage to the machinery.
- Close the cap: Once you have finished adding the hydraulic fluid and checking for leaks, close the cap on the hydraulic fluid reservoir securely.
- Start the excavator and run the hydraulic system for a few minutes to circulate the new hydraulic fluid.
- Check the hydraulic fluid level again to make sure it is within the correct range. Adjust the level as needed by adding more hydraulic fluid.
By following these steps, you can easily and safely add hydraulic fluid to your excavator and keep it running smoothly. It is important to regularly check and maintain the hydraulic fluid level to ensure the proper functioning of your excavator.
